External Control (I/O / Fieldbus) 11 DESKTOP ROBOT JR3000
FOR YOUR SAFETY
Danger
Do not use where flammable or corrosive gas is present.
Leaked gas accumulating around the unit causes explosions or fire.
Warning
Use protective gear such as a helmet, protective gloves, protective goggles,
and safety shoes when installing the robot and performing maintenance.
Failure to do so can cause injury.
Make sure that you securely install the unit in a place that can fully withstand
both the unit’s weight and its usage. Install the robot on a workbench 600 mm
or higher above floor level, in the center of the workbench.
In addition, for units with a cooling fan on the back, allow for 300 mm or more
clearance between the back of the unit and the wall.
Install the switchbox 600 mm or more above floor level in an easily accessible place.
If installation is inadequate, the unit can drop or fall over causing injury and unit
breakdown. Also, inadequate installation causes overheating or fire.
Make sure to power the unit within its rated current range.
Failure to do so causes electric shock, fire, or unit breakdown.
Plug the power cord into the power outlet firmly.
Failure to do so causes the plug to heat up resulting in fire.
Be sure to use the unit within its indicated voltage range.
Failure to do so causes unit breakdown, fire, or electric shock.
When replacing fuses, or inspecting or lubricating the unit, unplug the power
cord from the power outlet, then remove the cord from the main unit and
make sure there is no electrical current. Also, do not touch any of the power
inlet pins within 5 seconds of removing the power cords. Failure to follow
these steps causes electric shock or injury.
To Next Page
Loading...
