34
REPLACING THE FEED MOTOR
TO REMOVE:
1. Remove the front cover and rear covers (see page 7and 8).
2. Remove the snap ring (E-3).
3. Remove the two setscrews and remove the feed motor.
TO INSTALL:
4. To install the feed motor, follow the above procedure in reverse.
NOTE
Adjust the stretch stitch patterns (see page 22).
REPLACING THE FEED STITCH MOTOR
Snap ring (E-3)
Snap ring (E-3)
Feed motor
Setscrew (A)
Setscrew (B)
Access setscrew (B) through
this hole
To Next Page
Loading...
