Janome JW8100 - Getting Ready to Sew; Connecting Power Supply; Initial Setup and Operation

5
Using the start/stop button
Turn off the power switch.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
y Start/Stop button
NOTE:
The start/stop button does not work when the foot
control is connected.
GETTING READY TO SEW
WARNING:
While in operation, always keep your eyes on the
sewing area and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
q
e
r
t
y
u
w
w
r
t
e
y
q
Operating Instructions:
The symbol “O” on the switch indicates the “off” position
of the switch.
Foot control model 21371 or YC-485EC-1 is used with
this sewing machine.
For the U.S.A and Canada only:
For appliances with a polarized plug (one blade wider
than the other): To reduce the risk of electric shock, this
plug is intended to t in a polarized outlet only one way.
If it still does not t, contact a qualied electrician to
install the proper outlet. Do not modify the plug in any
way.
Connecting the Power Supply
Using the foot control
Turn off the power switch.
Insert the pin connector into the jack.
Insert the machine plug into the power inlet.
Insert the power supply plug into the wall outlet.
Turn on the power switch.
q Power switch
w Pin connector
e Jack
r Machine plug
t Power inlet
y Power supply plug
u Wall outlet
The foot control sign will be displayed when the foot
control is connected to the machine.
i Foot control sign
Before Using Your Sewing Machine
Before using your sewing machine for the rst time,
place a scrap of fabric under the presser foot and run the
machine without thread for a few minutes. Wipe away any
oil which may appear.
i