Janome Magnolia 7312 - Feed Lifting Cam

8. FEED LIFTING CAM
Check : 1. Turn the hand wheel to make needle
point position about above needle plate.
2. At this time, teeth of feed dog are required
to keep same height with that of needle
plate surface.
Adjustment : 1. Remove rear cover.
2. Loosen feed lifting cam set screw
(Hexagon M5x5) (A).
3. Turn feed lifting cam (B) up to same height
of feed dog teeth and needle plate surface,
(As F. 2 shown).
4. Tighten set screw (A).
(ALL MODELS)
A
B
FIG. 2
9