42
Mechanical adjustment
Presser foot lifter stopper position (2)
D
6. Remove the setscrews D.
Remove the thread motor unit from the carrying handle
supporter.
Be careful that the thread motor unit is still connected with
the cables.
(You may put the piece of soft fabric at the top of the
machine and place the motor unit on it while working, or
disconnect the needle threader motor cable from the
printed circuit board U1 and remove them together.)
Remove the setscrew E and the LED lamp unit.
F
G
7. Remove the setscrews F and G.
Remove the carryin handle supporter.
Carrying handle supporter
E
Supporter spring
LED lamp unit
H
I
8. Remove the supporter spring.
Remove the setscrews H and I.
Remove the front bracket.
Front bracket
To Next Page
Loading...
