Janome MC15000 - Y-Carriage Play Adjustment

53
Y-carriage
Lever
Cap
⇒
Inspection hole
Y fixing plate
Setscrew
X-carriage
Mechanical adjustment
Y-carriage play adjustment
There should be no play in the direction of arrow A (see fig. 1).
1. Push down the lever to open the Y-carriage.
2. Remove the cap under the embroidery unit (see fig. 2).
3. Move the X-carriage to the point where you can access the
Y fixing plate from the inspection hole (see fig. 2 and 3).
4. Loosen the setscrew.
5. Tighten the setscrew while pushing the Y fixing plate in the
direction of arrow (see fig. 3).
6. Be sure that there is no play in the Y-carriage in the
direction of arrow A (see fig. 1).
Attach the cap and return the X-carriage to the home
position. Close the Y-carriage.
Fig. 2
Fig. 1
Fig. 3
A