Janome MC9900 - Cloth Guide Start Position

39
1. Turn the power switch off. Attach the embroidery hoop.
(Do not open the Y-carriage.)
2. Attach the cloth guide to the embroidery carriage.
3. Turn the power switch ON while pressing the Start/
Stop button and the Reverse stitch button to enter the
factory setting mode.
Press "Cloth Guide" key.
4. Press " " key.
The cloth guide moves to the start position, and the
initial X value 1250 is indicated.
The initial X value is "1250".
5. Press " " key or " " to move the cloth guide to
the position 15 mm away from the center needle
position.
* Adjust the X value in the range of 1200 to 1300.
6. Press "OK" key.
⇒ ⇒ ⇒
Start/Stop button
Reverse
stitch button
Cloth guide start position
The distance between the cloth guide and center needle position should be 15 mm when the cloth guide is at the start
position.
Mechanical adjustment
X value
Cloth guide
15 mm
Center needle position
Guide position