57
Using the Stabilizer Plate
The stabilizer plate holds and supports the fabric so it is
helpful when sewing buttonholes over the hem of thick
fabrics.
z Insert the tab of the stabilizer plate q into the slot w
of the buttonhole foot.
q Stabilizer plate
w Slot
q
w
x Place the button on the button holder of the foot.
Attach the buttonhole foot to the machine.
Insert the fabric between buttonhole foot and stabilizer
plate. Press the needle up/down button twice and
remove the fabric to the left to draw both needle and
bobbin threads between the foot and stabilizer plate.
c Lower the needle into the starting point by turning the
hand wheel.
Lower the foot and buttonhole lever.
Start the machine.
NOTE:
The sewing procedure is exactly the same as that for
B1 sensor (square) buttonholes.
z
x
c
To Next Page
Loading...
