Janome MOD-19 - Adjusting Stretch Stitch Balance; Stitch Width Dial

15
Adjusting Stretch Stitch Balance
If the stretch stitch patterns are uneven when you
sew on a particular fabric, correct them by turning
the stitch length dial.
If the patterns are drawn out, correct them by
setting the dial to the “–” side.
If the patterns are compressed, correct them by
setting the dial to the “+” side.
q
w
Stitch Width Dial
Turn the stitch width dial to set the desired stitch
width at the setting mark .
The higher the number, the wider the stitch width.
q Stitch width dial
w Setting mark
NOTE:
Raise the needle above the fabric, when you
turn the stitch width dial.