Need help?Do you have a question about the Janome MS5027PR and is the answer not in the manual?
General| Number of Stitches | 27 |
|---|---|
| Maximum Stitch Width | 5mm |
| Maximum Stitch Length | 4mm |
| Weight | 6 kg |
| Dimensions | 400 × 188 × 298 mm |
| Stitch Length Control | Yes |
| Stitch Width Control | Yes |
| Reverse Stitch | Yes |
| Free Arm | Yes |
| Buttonhole Styles | 1-step |
| Foot Control | Included |
| Needle Threader | Built-in |
Procedures for removing and attaching the face cover.
Procedures for removing and attaching the top cover.
Procedures for removing and attaching the base plate.
Procedures for removing and attaching the bed cover.
Procedures for removing and attaching the belt cover.
Procedures for removing and attaching the free arm cover.
Procedures for removing and attaching the front cover.
Procedures for removing and attaching the rear panel.
Procedure for checking and adjusting top thread tension.
Procedure for adjusting presser bar height and alignment.
Procedure for adjusting the needle swing mechanism.
Procedure for checking straight stitch function.
Procedure for checking needle swing distribution.
Procedure for adjusting stretch stitch balance.
Procedure for checking and adjusting feed dog height.
Procedure for adjusting needle bar height.
Procedure for adjusting needle to hook timing.
Procedure for checking needle to hook clearance.
Procedure for checking and adjusting lower shaft gear backlash.
Procedure for checking buttonhole stitch balance.
Procedure for checking and adjusting needle position.
Procedure for checking and adjusting zero feeding.
Procedure for adjusting basic needle position.
Procedure for adjusting buttonhole length and function.
Procedure for adjusting bar tack timing for buttonholes.
Procedures for replacing and adjusting the needle threader plate.
Procedure for adjusting motor belt tension.
To Next Page
