Janome MS5027PR - Belt Cover; Free Arm Cover

9
MS5027PR
SERVICE ACCESS
BELT COVER
PULL OUT THE STITCH SELECTOR. LOOSEN THE SETSCREW (A) AND REMOVE THE SETSCREW
(B). PULL THE RIGHT SIDE OF BELT COVER IN THE DIRECTION OF THE ARROW, AS
ILLUSTRATED AND TAKE THE LATCH OFF, AND THEN REMOVE THE BELT COVER.
* WHEN YOU REATTACH THE BELT COVER, SET THE PROJECTION INTO THE GROOVE ON THE
FRONT COVER.
FREE ARM COVER
(TO REMOVE)
1. REMOVE THE SETSCREW (A) AND THE NEEDLE PLATE.
2. REMOVE THE BED COVER (SEE PAGE 8).
3. REMOVE THE SCREW (B) AND THE FREE ARM COVER.
(TO ATTACH)
4. FOLLOW THE ABOVE PROCEDURE IN REVERSE.
BELT COVER
PROJECTION
(B)
(A)
LATCH
(A)
(B)
NEEDLE PLATE
FREE ARM COVER
STITCH SELECTOR