Janome Skyline S7 - Attaching the Dual Feed Foot; Attaching the Darning Foot PD-H

19
w
q
e
w
Attaching the Dual Feed Foot
Attach the dual feed holder to the presser bar.
q Dual feed holder
Tighten the thumbscrew with your ngers.
Push the dual feed link to engage it with upper feed drive.
w Dual feed link
e Upper feed drive
Lower the presser foot lifter. Lower the needle to the
lowest position by turning the hand wheel.
Tighten the thumbscrew securely with the screwdriver.
q
w
Attaching the Darning Foot PD-H
Attach the darning foot PD-H to the presser bar by
putting the pin on the needle clamp screw.
q Pin
w Needle clamp screw
Tighten the thumbscrew rmly with the screwdriver.