95
Warning Sign Cause Try this
1. The start/stop button is pressed with the foot control
connected.
Disconnect the foot control.
The foot control is out of order. Contact the service center
or the store from whom the
machine was purchased.
The bobbin winder spindle is shifted to the right. Shift the bobbin winder
spindle to the left for
stitching.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
Lower the buttonhole lever
and start the machine again.
The twin needle key is pressed when the twin needle sign
is indicated on the LCD screen.
Replace the twin needle with
a single needle and press
the OK key.
The machine is started without lowering the feed dog with
button sewing selected.
Lower the feed dog.
The machine is started with the feed dog lowered. Raise the feed dog unless
you want to sew with the
feed dog lowered.
The needle plate is removed. Attach the needle plate.
Check if the needle plated is
attached properly.
The machine is halting due to overload.
Wait for at least 15 seconds
to restart. Remove tangled
threads around take-up lever,
hook race and automatic
thread cutting mechanism.
Problems and Warning Signals
If a buzzer sounds and the visual touch screen shows a warning sign, follow the guidance below.
To Next Page
Loading...
