Janome YC-482J-EC - Page 22

20
b Depress the foot control to sew a buttonhole.
The machine will sew the front bartack, left
row, back bartack and right row automatically.
Stop the machine at the ending point.
! 1 Ending point
n Raise the presser foot and cut the both needle
and bobbin threads leaving 10 cm (4˝) thread
ends.
Draw the needle thread to wrong side of the
fabric by pulling the bobbin thread.
Then, knot the threads.
m Remove the fabric and place a pin just before
the bartack at each end to prevent cutting
bartacks. Cut the opening with the seam
ripper.
! 2 Pin
! 3 Seam ripper
•Torepeatbuttonholesewing
, To repeat buttonhole sewing, turn the stitch
selector to , then back to again, as
shown.
Now, simply step on the foot control to sew
an identical buttonhole.
. When the buttonhole sewing is finished,
push the buttonhole lever upward as far as
it will go.
! 4 Buttonhole lever
•Adjustingbuttonholestitchdensity
Turn the stitch length dial to the right for a
coarser density.
Turn the stitch length dial to the left for a tighter
density.
1
2
3
4
0
!1
b
n m
!2
,
.
!3
!4