Jasic MIG SERIES - Side View Jasic MIG 200 CS

12
CONTROLS
Side view Jasic MIG 200CS
1. Wire inch buon: Pressing this buon acvates the feed motor which in turn pushes the welding wire
through the MIG torch and p
2. Gas purge buon: Pressing this buon acvates the gas solenoid which in turn acvates the gas ow
allowing you to correctly set the gas ow on the gas regulator
3. Wire spool holder and tensioner: Allows a 5Kg (200mm dia) reel of wire to be located in place via an
alignment pin and then locked in place with the locking nut. The spool holder also has a brake
arrangement to ensure correct tension of the wire, this is done by turning the central bolt with an
Allen key clockwise (to ghten) or an clockwise (to loosen)
4. Inlet wire guide: The welding wire is fed through the inlet guide prior to feeding through the drive
rollers
5. Wire feed roller and retaining nut: Secures and holds the grooved drive roller in place
6. Outlet feed adaptor: Part of the Euro outlet connector which contains the inner outlet guide which
ensures smooth wire feed from the drive assembly through to the MIG torch
7. Pressure roll assembly: Holds the upper drive roll in place which applies pressure to the welding wire
onto the grooved drive roller
8. Drive roll tensioner: Allows the correct amount of tension to be applied to the top roller to ensure
good feed of the wire through the MIG torch