Jasic MIG160PFC - Page 45

Page 45
7.3.4 Start welding
Description of MIG 2T/4T operation
2T operation mode
4T operation mode
Step 1: Press the torch trigger to start
welding.
Step 1: Press the torch trigger for the first time to
start welding.
Step 2: Release the trigger to stop
welding.
Step 2: Release the trigger for the first time to
continue welding.
Step 3: Press the trigger for the second time to
resume welding.
Step 4: Release the trigger for the second time to
stop welding.
I
U U
0
U
VRD
(Lift TIG process)
Note! When starting arc, the short-circuit time exceeds 2s, the welder turns off the
output current, and it is necessary to lift the welding torch and short-circuit the
tungsten electrode and workpiece again before starting arc again.
Note! In the welding process, if there is short circuit between tungsten electrode and
workpiece, the welder will immediately reduce the output current; if the short circuit
time exceeds 1s, the welder will turn off the output current, and the welding torch
needs to be lifted to start the arc again.
7.3.4 Turn off the power supply after welding
(Same as section 7.1.7)
Short circuit Arcing