Page 23
5.7. Installation of wireless receiver module (optional)
(Installation of wireless receiver module)
1) Remove the wireless remote controller plug cover shown in the above left figure (a).
Refit into the wireless receiver module shown in the above right figure (b).
2) Remove the screws on the left side cover of the machine and remove the side panel.
3) Connect the cable of the wireless module to the 7P terminal block CN3 of the control board
PCB2 (Figure c).
NOTE! The standard version does not support the remote controller. Please check
that the machine supports wireless handheld remote controller before installation.
To Next Page
Loading...
