Page 60
7.1.7 Turn off the power supply after welding
The power switch is located on the rear panel of the machine and set it to the "OFF" position.
After a time delay, the panel indicator is off and the welder stops working.
7.2. MMA operation
7.2.1 Turn on the power switch
(Same as section 7.1.1)
7.2.2 Select welding mode
For HD digital screen, use the "Welding Mode Selection" key to select MMA mode;
For LCD screen, select "MMA" on the Home page and press the master encoder to enter
MMA mode.
(Select MMA mode in HD digital screen) (Select MMA mode in LCD screen)
7.2.3 Set MMA parameters
1) For HD digital screen, use the "Parameter Adjustment Knob A" to set the "Welding
Current"; for LCD screen, use the master encoder to set the "Welding Current"; (as shown in
To Next Page
Loading...
