Page 52
7. Welding function operation
Warning! Before turning on the power supply make sure that the equipment
is disconnected to the output. Otherwise, an unexpected arc may be started
when the power is turned on. This can cause damage to the work piece and
to personnel.
Warning! Be sure to wear appropriate protective equipment during welding
or cutting operation. Arcs, spatter, smoke, and high temperatures produced
in the process may cause injury to personnel.
Warning! After the power supply is turned off, the output voltage of the
machine may continue for a period and then drop slowly. Please do not touch
the conductive part of the output before the panel is extinguished.
7.1. MIG operation
NOTE! Some models are equipped with the smart fan function. When the power
supply is turned on for a period before welding or cutting, the fan will automatically
stop running. It will run automatically when welding or cutting begins.
7.1.1 Turn on the power switch
The power switch is located at the rear panel of the machine; set it in the "ON" position; then
the panel indicator will light up, the fan will start to rotate, and the welder will start to work
normally.
To Next Page
Loading...
