Page 51
automatically;
· The overcurrent protection cannot be automatically released; unless the welder is
turned off and restarted. If the overcurrent protection remains after restarting, please
contact the sales department of the company.
2. VRD function display
In MMA mode, the VRD function can be enabled or disabled: if VRD is enabled, the VRD icon
will be displayed; if VRD is disabled, the VRD icon will not be displayed. The VRD icon
position is as shown in the following figure.
1) When not welding, the VRD icon displays green , indicating that the VRD function is
normal.
2) When not welding, the VRD icon displays red , indicating that the VRD function is
abnormal.
3) When welding, the VRD icon is not displayed.
To Next Page
Loading...
