46
Entrance Door Step(s)
Carefully clean the area around the pivot points (the
rivets involved in the motion of the mechanism).
Lubricate these pivot points with an automotive
grade, non-staining lubricant every 30 to 60 days.
Wipe any excess lubricant o of the step and then
clean the entire step after lubricating.
Your RV may be equipped with a switch located on the skirt (in front of the steps) which
operates a light located under the step assembly.
Entrance Door
Always hold onto the entrance door when opening or closing it. Damage caused because
you failed to do so is not covered by the
The entrance screen door may be equipped with a slide panel that allows access to the
entrance door handle and locks. The entrance door may also be equipped with both a regular
door lock and a dead bolt lock.
Keys
Several keys are provided when you purchase your vehicle. Most keys have an individual
key number stamped on the plate. Record these key numbers and keep the information in a
safe place. You can order a key blank from your dealer to have duplicate keys made. If you
lose the keys, contact your dealer or a locksmith for assistance.
Make sure the entrance door is completely closed and locked when traveling.
Locking the door helps prevent it from opening unintentionally and keeps
intruders from your recreation vehicle.
Locks on entrance and baggage doors need biannual lubri-
cation using a light coat of silicone spray. Conditions such as rain,
salt, dust and pollution may increase the maintenance needs.
Rear Backup Camera Prep
Your recreation vehicle has been pre-wired to allow for installation of a (customer supplied
& customer installed) rear backup camera. Wiring is in place to install the camera at the rear
of the vehicle, and has been routed to the master bedroom to allow a hookup for the camera
monitor. This feature also allows you to use also use your camera as a security monitor.
To Next Page