EasyManua.ls Logo

Jayco Hummingbird 2018 - Emergency Stopping

Jayco Hummingbird 2018
159 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

48
Emergency Stopping
Always carry road ares or reective warning signs. Pull o the roadway as far as possible
for emergency stopping. Turn ON your vehicle hazard warning ashers. If traveling at
night, use three red warning indicators such as ares, reectors or lanterns as required by the
Uniform Vehicle Code and Model Trac Ordinance as follows:
1. Place the rst warning indicator on the trac side of the recreation vehicle, directed at
the nearest approaching trac.
2. Place the second warning indicator 100 feet behind the recreation vehicle in the center
of the lane and toward approaching trac.
3. Place the third warning indicator 100 feet in front of the recreation vehicle in the center
of the lane and away from the trac approaching from behind.
 Curves and/or hills may affect the safe placement of warn-
ing indicators.


Emergency Towing
If your recreational vehicle needs to be towed, please contact an emergency road service
provider or a qualied service facility for assistance.
Never allow anyone to go under the recreation vehicle while it is being lifted
and/or being towed.

Wheel Lugs
After your rst trip, check the wheel lug torque periodically for safety. Check the wheel
lugs after winter storage, after a wheel removal, before starting a trip or following extensive
braking. .
1. Use the correct star pattern sequence to attach the recreation vehicle wheels
2. Start all nuts by hand to prevent cross threading.
3. Tighten the nuts in the sequence shown.
4. Tighten the lug nuts equally in stages as indicated for your recreational vehicle wheels

Control switches for the stabilizer jacks are typically located on the (door) side of the unit
above the stabilizer jack(s).
To lower each jack, press the control switch until each leg contacts the ground and stabilizes
the unit.
To raise the jack, press the control switch until the jack is returned to the retracted position.



Table of Contents