59
Locate and separate the quick disconnects located in the motor
arm channel. Position the wires from the motor on the outside of
the channel.
7. Attach jumper wires to the motor wires. Connect the other
ends of the jumper leads to the 10VDC–14VDC source. If
the awning moves in the wrong direction, reverse the leads.
8. Maintain contact throughout the retraction process.
9. Hold the wires from the motor on the outside of the channel
while closing the awning. This provides access for opening
the awning.
10. When power is restored, use the jumper wires and extend
the awning to access the cable disconnects. Re-attach the
disconnects and secure in the arm channel.
When rolled out, the fabric may “bounce” creating a wave like motion in the canopy
fabric. This can creates the appearance of moving jerkily.
Vinyl may have a tendency to “cling” to the when not used for an extended period of
time. Open and close the awning in short bursts 2 or 3 times, the awning will then open
normally.
If the awning does not operate, contact the Carefree Service Center. See www.
carefreeofcolorado.com for a listing of service centers.
If the awning is equipped with the Direct Response
system, this procedure is not applicable. See the manufacturer’s
owner’s manual for additional information.
To Next Page