Jayco PINNACLE - Page 102

92
FUEL & PROPANE SYSTEM
DOT propane cylinders must be transported and stored in an upright position
so the pressure relief device will function properly. Laying a DOT propane
cylinder on its side may potentially create a very dangerous situation.
9#40+0)
NOTE: Tanks are to be installed, fueled and maintained in accor-
dance to State and Local codes, rules, regulations or laws.
HTXLSSHGZLWKDQDXWRPDWLFVWRS¿OOYDOYHGHVLJQHGWRUHGXFHWKHSRWHQWLDORIRYHU¿OOLQJ
ASME propane tanks are also equipped with a P.O.L. service valve that is for connection of
WKHVXSSO\KRVHZLWKDOHIWKDQGWKUHDGHGEUDVV32/¿WWLQJIURPWKHWDQNVHUYLFHYDOYHWR
the two-stage regulator. Not for use on gas grills and other low pressure devices.
Propane is a true gas compressed into a liquid form. As the fuel is released from the container,
it changes to vapor which is then used for the operation of the appliances. Propane will not
run through the appliances in the liquid state.
Propane expands 1½ percent for every ten degrees of increase in temperature. It is imperative
WROHDYHVXI¿FLHQWVSDFHLQVLGHWKHFRQWDLQHUWRDOORZIRUQDWXUDOH[SDQVLRQRIJDVGXULQJ
warmer weather.
The main shut off valve must be kept closed at all times unless you are using the propane
V\VWHPRU ¿OOLQJWKH SURSDQHF\OLQGHU:KHQ WKHF\OLQGHU LVGLVFRQQHFWHGIURP WKHKRVH
install the valve cover that is attached to the container.
Close the propane cylinder main shut off valve by hand tightening only. Use of tools creates
a potential to over tighten the valve (damaging the interior seals on the cylinder valve seat).
If this type of damage occurs, the cylinder will not close properly.
7KHIROORZLQJODEHOVKRXOGEHNHSWSHUPDQHQWO\DI¿[HGWR\RXU59
“Use propane only” label
(Canada only)
(Label appearance may not be exact)