33
PRE-TRAVEL INFORMATION
DO NOT USE THE FIFTH WHEEL LANDING GEAR TO SUPPORT
THE TOW VEHICLE WEIGHT. 7KH¿IWKZKHHOODQGLQJJHDULVGHVLJQHG
to bear the front loaded weight of the RV only.
9#40+0)
FIFTH WHEEL LANDING GEAR
7KH¿IWKZKHHOODQGLQJJHDUFDQEHRSHUDWHGPDQXDOO\7KH¿IWKZKHHOODQGLQJJHDUPXVWEH
fully retracted before moving or towing the RV to prevent damage.
Equipment that sometimes gives autos, trucks and sport utility vehicles a softer ride can
accentuate swaying when pulling a RV; conversely, suspension that is too stiff will increase
vibration, bounce and accelerate wear of your tow vehicle and RV combination.
Jayco cannot be responsible for the suspension system of any tow vehicle. There are
a variety of tow vehicle suspension systems available that will affect the ball height,
stability and levelness of a hooked up RV.
Make sure your dealer is aware of the tow vehicle you are using so a compatible hookup is
achieved.
Fifth wheel pin box
7KH¿IWKZKHHOIDFWRU\LQVWDOOHGSLQER[LVQRWLQWHUFKDQJHDEOH0DLQWDLQWKHSURSHUSLQER[
weight on the hitch.
Fifth wheel pin box height
7KHUHLVQRUHFRPPHQGHGKLWFKKHLJKWIRU¿IWKZKHHOVXVXDOO\WKH¿IWKZKHHOSLQER[LV
adjustable for variance in trucks and truck suspension systems.
$GMXVWWKHKLWFKDVVHPEO\VRWKHWRZYHKLFOHDQGWKH¿IWKZKHHODUHHVVHQWLDOO\OHYHO$KLJK
KLWFKZLOOWUDQVIHUZHLJKWEHKLQGWKHD[OHVDQGFDXVHWKHYHKLFOHWR¿VKWDLO
A low hitch will transfer additional weight to the hitch. Refer to the hitch manufacturer
instructions to adjust the weight distributing hitch to the proper height.
FIFTH WHEEL HITCHING PROCEDURE
+RRNLQJXSD¿IWKZKHHOZLOOEHFRPHHDVLHUZLWKSUDFWLFH7KHIROORZLQJSURFHGXUHZLOO
help until you become more experienced.
1. Make sure the trailer wheels are blocked.
2. Make sure the hitch lever is in its open or “cocked” position unless it has been designed
WR RSHQ DXWRPDWLFDOO\$GMXVW WKH ¿IWKZKHHO WUDYHO WUDLOHU SLQ WR WKH SURSHU KHLJKW
Lower the tailgate, if applicable.
3. %DFNWKHWUXFNVRWKHKLWFKHQFLUFOHVWKH¿IWKZKHHOWUDYHOWUDLOHUSLQ
4. A gentle contact of the hitch saddle against the pin will cause the mechanism to close.
5. 6HFXUHWKHKLWFKOHYHUDVVSHFL¿HGE\WKHPDQXIDFWXUHU
6. Put the truck in drive (DO NOT press on the accelerator) and ‘bump’ the hitch to make
sure it is locked.
7. %HVXUHWRUDLVHWKH¿IWKZKHHOODQGLQJJHDUDOOWKHZD\XS
8. Attach the breakaway switch cable to the tow vehicle.