Jayco PINNACLE - Page 104

94
FUEL & PROPANE SYSTEM
INSTALLING PROPANE CYLINDER(S)
Located in a recessed compartment or housing (if so equipped)
1. Connect the 3/8” low-pressure hose to the outlet of the two-stage regulator.
2. Place the cylinder on the bracket in the recess compartment or housing and secure them
so the outlets of the cylinder valves are facing the “sidewalls” of the compartment or
housing (opposite of each other).
3. Mount the regulator on the center back wall of the compartment or housing so the vent
is pointed downward.
4. $WWDFKWKH´LQYHUWHGÀDUH[´7\SHSLJWDLOKRVHWRWKHUHJXODWRULQOHWDQGWKH
right hand swivel nut to the cylinder valve.
Main Supply Hose – Low Pressure
$WWDFKWKHPDLQVXSSO\KRVHIURPWKHUHJXODWRUWRWKHEUDVVPDQLIROG¿WWLQJLQWKHIUDPHRI
WKHWUDLOHU7KHVZLYHOEUDVVQXWRQWKHPDLQKRVHZLOOEH\RXU¿QDODWWDFKPHQW
.
7KHIROORZLQJODEHOVKRXOGEHNHSWSHUPDQHQWO\DI¿[HGWR\RXU59
Refer to your Warranty Packet for more information on the LP gas system components.
“Do not fill to more than
´ODEHO
(Label appearance may not be exact)
Ensure that all fasteners are secured before traveling.
9#40+0)
Two propane cylinders
Main supply hose