Jayco PINNACLE - Page 142

132
PLUMBING SYSTEM
TOILET
7KH WRLOHW LV HI¿FLHQW DQG HDV\ WR RSHUDWH *HQHUDOO\ PRUH ZDWHU LV UHTXLUHG RQO\ ZKHQ
ÀXVKLQJVROLGV3ULRUWRXVLQJWKHVDQLWDWLRQV\VWHPLWLVVWURQJO\UHFRPPHQGHGWRÀXVKWKH
WRLOHWVHYHUDOWLPHVWRUHOHDVHVXI¿FLHQWZDWHULQWRWKHKROGLQJWDQN,IWKHUHLVQRWDVXI¿FLHQW
DPRXQWRIZDWHUXVHGGXULQJÀXVKLQJWKHZDVWHPDWHULDOVPD\QRWHYDFXDWHSURSHUO\IURP
the drain line to the tank. Clogged tanks and pipes could eventually occur.
7KH WRLOHW V\VWHP ZLOO SHUIRUP EHWWHU ZKHQ ZDWHU LV UXQ IRU WHQ WR ¿IWHHQ VHFRQGV DIWHU
ÀXVKLQJWRHQVXUHWKDWWKHZDVWHZLOOSURFHHGWRWKHERWWRPRIWKHWDQN
8QOLNHDWRLOHWLQDKRPHZKLFKPD\XVHXSWRVHYHQJDOORQVRIZDWHUSHUÀXVKWKHDYHUDJH
recreation vehicle system uses one to three quarts (1 - 3 liters). For added convenience and
better sanitation system performance, it is advisable to always have four to six inches (10 -
15 cm) of water in the toilet.
The tank heater switch should be turned ON:
 When liquid is present in the holding tanks and the outside temperature approaches and
maintains freezing conditions 35°F (2°C) or colder.
The tank heater switch should be turned OFF:
 When there is NO liquid present (tanks are empty).
 When dumping the black and gray holding tanks and the drain pipes.
 When fresh water tank and supply lines are empty or being drained for storage.
 When the recreation vehicle is connected to city sewer and the gate valves are open.
NOTE: Free draining is never recommended, especially in cold weather use.
 When ambient temperatures rise and remain above freezing.
No maintenance on the heaters is required, only a periodic inspection for loose wires,
damage, etc. For additional detailed information, refer to the tank heater manufacturer’s
user guide.
To prevent help toilet blockage, always use RV grade single-ply toilet paper.
'RQRWÀXVKSDSHUWRZHOVGLDSHUVVDQLWDU\QDSNLQVRURWKHUIRUHLJQREMHFWV
down the toilet.
%#76+10
It is important to add enough water to prevent solid waste buildup. Follow the
directions listed below and in the manufacturer’s operator manual.
%#76+10
It is important to prevent solid waste buildup. Follow the toilet manufacturer’s
recommended instructions each time after emptying the black water holding
tank.
9#40+0)