42
VEHICLE OPERATION
Dead Bolt Locks Two short beeps
Dead Bolt Unlocks Two short beeps
Dead Bolt fails to Lock One long beep
Dead Bolt fails to Unlock One long beep
Low Battery One Long beep after the Lock/Unlock beeps
The lock will cycle up to 10 more times once the low battery indication occurs. After this
WKH¿QDOHOHFWULFIXQFWLRQLQDORZEDWWHU\FRQGLWLRQZLOOEHXQORFNDQGZLOOQRWORFNXQWLO
the batteries have been replaced. Please note that if the deadbolt is in the locked position and
the batteries die the deadbolt will remain locked. The key will always be able to activate the
deadbolt lock.
Please enter your Personal Code to prevent inadvertent programming
General Maintenance and Operating Guidelines
Install fresh batteries as necessary. The lock is designed to function for months of
normal usage with fresh, high quality AA batteries. Battery life is highly dependent
upon battery quality, usage, and environment (temperature).
Make sure there are no obstructions in the door frame to prevent Dead Bolt extension.
Do not wash with power washer or high pressure cleaner. The lock is designed to resist
water intrusion to protect its electrical components from normal water encounter such
as rain.
The lock uses Touch Technology. The buttons are activated by touching not pressing.
Remove batteries when storing or not using this lock for extended periods of time.
(Note: the factory code will reset when the batteries are removed for longer than 10
seconds)
Rain Sensing Technology:
The lock system has Rain Sensing Technology to preserve battery life. Rain will wake up
the touch pad and illuminate the buttons. After a few seconds of contact from rain (water)
the lights turn off, but a code can be entered and the lock will function normally. The same
effect occurs if the operator touches a button for a prolonged period of time. The buttons
will illuminate, but then turn off. Again the lock will function normally.
To Next Page
Loading...
Need help?
General