27
TROUBLE SHOOTING AND MAINTENANCE
Turn off the controller, check the lever, make sure the lever is not bent and broken, and
be sure to retiun to it when you release it. Check the nibber base of the lever for
damage. Just check the base and do not repair it. If you have any questions, please
Disconnect the controller coimector and charger comiector fiom the batteiy compait
ment. check the connection and for corrosion. If necessary, please contact tlie dealer.
Make sure that all parts of the controller are tightly connected to the product, do not
screw the screws too tiglitly.
Check the brakes. This inspection must be canied out on a level siuface and there must
be enough open space aroiuid.
Tum on the controller. After one second. check the batteiy indicator to make sure the
Slowly push the lever forwaid to guide you to hear the "beep” of the brakes, and im
mediately release the lever. You must hear the brake operation sound after each
lever is pushed for a few seconds:
Repeat the operation tluee times to push the controller to the rear, left and riglit sides
1. Daily check
2. Weekly check
3. Monthly check
4. Storage
1.
2.
3.
Maintenance Frenq uecy
Check the anti-roll wheel for excessive wear and replace the wheel if necessary.
Check the wear of the front wheels and drive wheels. If maintenance is required.
please contact your dealer.
Check the front fork for wear and looseness, which may indicate that adjustment is
needed or the bearing needs to be replaced. Please contact the dealer for repair, or
Keep the product clean and do not leave debris, such as food, beverages, residues,
1.
2.
3.
4.
This product should be stored in a cool and dry environment. Do not store it at the ex
treme temperature. If it cannot be stored under the above conditions, it may cause rust
ing of the wheelchair, and damage to the electrical system. Storage conditions: tempera
Atmospheric pressure: 86kPa
www.jbhmedical.com
To Next Page
Loading...
