JBH D26 - Guidelines and Manufacturers Statement-Electromagnetic Immunity

32
GUIDELINES AND MANUFACTURER' S STATEMENT-ELECTROMAGNETIC IMMUNITY
Surge
30 A/m 30 A/m
U
T
Guidelines and manufacturer' s statement-Electromagnetic Immunity
Anti-interference
measurement
Coincidence level
IEC60601 Test Level
Electromagnetic
environment-
Guidelines
Electrostatic
discharge
(ESD)
ISO7176
IEC60601
ISO7176
IEC60601
ISO7176
IEC60601
ISO7176
IEC60601
ISO7176
IEC60601
±6 kV Contact discharge
±2kV To the power cord ±2kV To the power cord
±8 kV Air discharge
±6 kV Contact discharge
±8 kV Air discharge
D26
Power Wheelchair
is expected to be used in the electromagnetic environment
specified below, and the buyer or user of the electric wheelchair vehicle shall
ensure that it is used in this electromagnetic environment.
Electrical fast
transient burst
The floor should be
wood, concrete or
ceramic tile, and if
the floor is covered
with synthetic mate
-
rials, the relative
humidity should be
at least 30%.
The power supply
in the hospital or in
the commercial en
-
vironment should
be of typical quality.
The power supply
in the hospital or in
the commercial en
-
vironment should
be of typical quality.
The power supply
in the hospital or in
the commercial en
-
vironment should
be of typical quality.
If the users of elec
-
tric wheelchair need
continuous opera
-
tion during power
interruption, unin
-
terruptible power
supply or battery
power supply is rec
-
ommended.
The power frequen
-
cy magnetic field
should have the
horizontal charac
-
teristics of power
frequency magnetic
field in typical com
-
mercial or hospital
environment.
mercial or hospital
environment.
mercial or hospital
Note: refers to the AC network voltage before the test voltage is applied
U
Note: refers to the AC network voltage before the test voltage is applied
U
T
Note: refers to the AC network voltage before the test voltage is applied
T
U
T
U
Note: refers to the AC network voltage before the test voltage is applied
U
T
U
<5% U
T
, Last for 0.5
circuits
（
on U
T
,>95%
sag
）
40% U
T
,Last for 1 cir
-
cuit
（
on UT,60% sag
）
70 % U
T
，
Last for 25
circuits
（
on U
T
,30%
sag
）
<
5% U
T
,Last for 5 sec
-
onds
（
on U
T
,>95%
sag
）
<
5% UT, Last for 0.5
circuits
（
on UT, >95%
sag
）
40% UT, Last for 1 cir
-
cuit
（
on UT,100% sag
）
70 % UT
，
Last for 25
circuits
（
on UT,30%
sag
）
<
5% UT, Last for 5
seconds
（
on
UT ,>95% sag
）
Voltage sag,
short int errup
-
tion and voltage
variation on
power in put line
Power frequency
magnetic field
Power frequency
magnetic field
Power frequency
（
50/60Hz
）
±1 kV
Differential-mode
voltage
±2 kV Common mode
voltage
±1 kV
Differential-mode
voltage
www.jbhmedical.com