BASIC OPERATION
CHARGING BATTERIES
Before operating your D26 Power Power Wheelchair, be sure to read all safety informa-
tion and precautions included in this manual. Operate only in the appropriate environment
after you have practiced operation the wheelchair and know how to work the controller.
Be certain that the power is OFF before sitting in the
seat of Fold Power Wheelchair D26, with no light on
the controller, make sure the footrest is down before
getting into the wheelchair.
Press the Power button, you will ear a beep and a
light will indicate that power is on.
Use the joystick style control to steer and turn left,
right or go forward and backward.
Simply remove your hand from the joystick to stop.
When stopping, it is advised that you power OFF the
wheelchair to prevent accidents. Press the power
button to turn off the wheelchair.
Make sure there is no light on the controller before
getting off the wheelchair.
GET IN
POWER ON
TURING &STEERING
STOPPING
POWER OFF
GET OUT
Your D26 wheelchair will arrive with full charged batteries, which should last about 18 km
under normal operation conditions. We recommend that you run the D26 PowerWheelchair
until the batteries are completely dead in order to get the most out of the battery life.
Charge both batteries at the same time via controller charge port.
Turn the power off.
Plug in the charger to the controller port (see below), please notice connect the char-
ger cable first, then turn the power on.
◎ First charging method
1.
2.
19
www.jbhmedical.com
To Next Page
Loading...
