8
7. SOUND SETTING
This section helps you choose the ideal sound for your video or
music.
Before you start
• Make the necessary connections described in the user manual.
• On the soundbar, switch to corresponding source for other
devices.
Adjust the volume
• Press VOLUME +/- button to increase or decrease a volume
level.
• To mute sound, press MUTE button.
• To restore the sound, press MUTE button again or press
VOLUME +/- button
Choose sound effect
1. Bass
• Change low frequency (bass) settings of the soundbar.
• Press BASS +/- to change the subwoofer volume level.
2. Sound mode
q 2DKDBSOQDCDjMDCRNTMCLNCDRSNRTHSXNTQUHCDNNQLTRHB
• Press SOUND button to select a sound option from the
display panel.
• Select the STANDARD mode if you want to enjoy the
original sound.
• Select the MUSIC, MOVIE, VOICE, SPORT mode
depending on the content you want to listen to.
• When the wireless surround speakers are detached from
SGDL@HMA@QRNTMCLNCDRED@STQDRODBHjBADG@UHNQR
Sound Mode What you hear in the detached
wireless surround speakers
Standard Ambience and special effects
Music Mono Mix
Movie Ambience and special effects
Voice Mono Mix
Sports Ambience and special effects
3. Night mode
• For quiet listening, night mode decreases the volume of
loud sounds when audio is played.
• Night mode is only available for Dolby Digital or DTS
soundtracks.
• Press NIGHT MODE button to turn night mode on or off.
Press and hold 5 seconds SOUND button to reset default
audio setting.
Synchronize video and sound
• If the audio and video are not synchronized, delay the audio
to match the video.
• Press AUDIO SYNC +/- button to synchronize the audio
with the video.
8. AUDIO CALIBRATION
Audio Calibration will optimize the wireless speaker sound settings
for a better surround sound experience.
Remove the wireless surround speakers from the soundbar.
Connect the microphone into the connector on the right side of
the soundbar.
Place the microphone at ear-level at the listening position. For best
surround sound effect, position the wireless surround speakers to
the sides and slightly behind the listening area.
Be sure to point the narrow side of the surround speaker towards
the listening area, and remove any obstruction between the
microphone and the wireless surround speakers.
Press and hold the calibration button for 3 seconds. The calibration
sequence will begin with a countdown.
>3 s
1
2
3
DONE
To Next Page
Loading...
Need help?
General
Weight and Dimensions
