6
Section 3: EON208P
PA
System Declaration
of
Conformity
This equipment complies with the EMC directive 89/336/EEC
Modified by
92/31/EEC
93/68/EEC
98/13/EEC and
LVD
73/23/EEC modified by 93/68/EEC
This product meets safety standards:
EN60065:2002
UL6500 7th Edition: 2003
UL
60065-
STANDARD FOR AUDIO, VIDEO AND SIMILAR ELECTRONIC
APPARATUS- SAFETY
EQUIREMENTS-
Edition
7-
Revision Date 2007/12/11
CSA C22.2 NO
60065-03-
AUDIO, VIDEO AND SIMILAR ELECTRONIC
APPARATUS-
SAFETY
REQUIREMENTS-
Edition 1 - Revision Date 2006/04/01
IEC
60065-
AUDIO, VIDEO AND SIMILAR ELECTRONIC APPARATUS
--SAFETY
REQUIREMENTS-
Edition
7.1
-Issue
Date 2005/12/01
And EMC Standards
EN551 03-1 (E2)
EN551 03-2 (E2)
FCC Compliance Notice
CE
This device complies with part 15
of
the FCC rules. Operation
is
subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part
of
the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference
in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used
in
accordance with the instruction manual, may cause harmful interference to radio
communications. However there is no guarantee that the interference will not occur
in
a particular installation. If
this equipment does cause harmful interference to radio and television reception, which can be determined by
turning the equipment off and on, the user
is
encouraged to try to collect the interference by one or more
of
the
following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet
on
a circuit different from that to which the receiver is connected
• Consult the dealer
or
an experienced radio/TV technician for help
To Next Page
Loading...
