JBL EON 208p - Connect the Mixer Module to the Speakers; Connecting the AC Power Cable

8
4.
Connect the Mixer
Module
to
the Speakers
On
the back side
of
the mixer you
will notice two
V4
11
phone jacks - these are your speaker output jacks.
Take the speaker
cables
and connect them from these jacks to the jacks on the back
of
the speakers.
To
Left
speaker
To
Right
speaker
5.
Connecting the AC Power Cable
Connect the
female
end
of
the power cable
to the mixer and
plug
the
male
end into the
wall
socket
or
extension cord. Turn the
"MASTER VOLUME" control
to
"0".
Now turn the power switch to the "on"
position.
You
should
see the
"POWER" indicator
illuminated.
At
this
point
you
are ready
to
bring
in an audio signal
and hear the
signal amplified
by
the system.