To Next Page

To Previous Page

SAFETY PRECAUTIONS

The following check should be performed for the continued

protection of the customer and service technician.

LEAKAGE CURRENT CHECK

Measure leakage current to a known earth ground (water

pipe, conduit, etc.) by connecting a leakage current tester

between the earth ground and all exposed metal parts of the

appliance (input/output terminals, screwheads, metal

overlays, control shaft, etc.). Plug the AC line cord of the

appliance directly into a 120V AC 60Hz outlet and turn the

AC power switch on. Any current measured must not exceed

o.5mA.

ANY MEASUREMENTS NOT WITHIN THE LIMITS

OUTLINED ABOVE ARE INDICATIVE OF A

POTENTIAL SHOCK HAZARD AND MUST BE

CORRECTED BEFORE RETURNING THE APPLIANCE

TO THE CUSTOMER.

Device

under

test

Test all

exposed metal

surfaces

Also test with

plug reversed

(Using AC adapter

plug as required)

AC Leakage Test

Leakage

current

tester

Reading should

not be above

0.5mA

Earth

ground

3-3

Other manuals for JBL FLIP 3

Questions and Answers:

Need help?

Do you have a question about the JBL FLIP 3 and is the answer not in the manual?

General

Speaker type	-
Driver diameter	40 mm
Number of drivers	2
Number of speakers	1
Audio output channels	- channels
Impedance	- Ω
Frequency range	85 - 20000 Hz
RMS rated power	16 W
Signal-to-Noise Ratio (SNR)	80 dB
Bluetooth version	4.1
USB charging port	Yes
Bluetooth profiles	A2DP, AVRCP, HFP, HSP
USB connector type	Micro-USB
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wireless
Battery voltage	3.7 V
Battery capacity	3000 mAh
Power source type	Battery
Battery life (max)	10 h
Battery recharge time	3.5 h
Product color	Turquoise
Protection features	Splash proof
Recommended usage	Universal
Quantity per pack	1 pc(s)