EasyManuals Logo

JBL FLIP 3 Service Manual

JBL FLIP 3
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
1.5.2 Battery Charging Time
System at Power off mode, charging time is less than 3. Hour using Harman 5V/2.3A adaptor.
1.5.3 Battery power off current
System at power off mode, battery current is less than 100uA
1.5.4 Battery Playtime
Test Audio Signals:
3 pre-selected MP3 tracks
Requirements:
Estimate Playtime > 8 hours for Music Playback
Test Condition (Ambient Temperature 23 +/-5 degree)
1. Insert fresh and fully charged Li-Poly cells into the DUT. Connected a multi-meter at the battery
terminals to measure its voltage.
2. Set the DUT to Bluetooth Mode. Use iPhone as the music source.
3. Set the DUT to maximum volume and playback a 1 KHz 0dB music track through the iPhone. Record
the Rated Output Power (ROP).
4. Adjust the volume step of the iPhone until the audio output of the DUT is ¼ of ROP. Record the
volume step on the iPhone.
5. Set the iPhone’s volume to the volume step as recorded in step 4. Playback 3 pre-selected MP3
track in repeat play mode. Record the start time.
6. Measure the battery voltage every 5 to 10 minutes interval. When audio is inaudible, record the end
time. Compute the battery playtime for 3 pre-selected MP3 track.
Note, please don’t adjust iPhone’s volume during set up and testing since that will change the DUT’s
volume by AVRCP.
2-6

Other manuals for JBL FLIP 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JBL FLIP 3 and is the answer not in the manual?

JBL FLIP 3 Specifications

General IconGeneral
Speaker type-
Driver diameter40 mm
Number of drivers2
Number of speakers1
Audio output channels- channels
Impedance- Ω
Frequency range85 - 20000 Hz
RMS rated power16 W
Signal-to-Noise Ratio (SNR)80 dB
Bluetooth version4.1
USB charging portYes
Bluetooth profilesA2DP, AVRCP, HFP, HSP
USB connector typeMicro-USB
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technologyWireless
Battery voltage3.7 V
Battery capacity3000 mAh
Power source typeBattery
Battery life (max)10 h
Battery recharge time3.5 h
Product colorTurquoise
Protection featuresSplash proof
Recommended usageUniversal
Quantity per pack1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth64 mm
Width169 mm
Weight450 g

Related product manuals