SDP-40HD Setup
3-51
ON-SCREEN DISPLAY
The ON-SCREEN DISPLAY option opens the ON-SCREEN DISPLAY menu, to customize the on-screen display.
STATUS ALWAYS ON, 2 SECONDS, ALWAYS OFF
Controls the activation of the on-screen display when the display
device is connected to a Main Zone video output connector. When
ALWAYS ON is selected, the on-screen display remains activated at all
times. When 2 SECONDS is selected, the on-screen display activates
for two seconds whenever a new input source is present or a new
command is received. When ALWAYS OFF is selected, the on-screen
display remains deactivated at all times, and will not reactivate until the
STATUS parameter is set to ALWAYS ON or 2 SECONDS.
Note:
When the ON-SCREEN DISPLAY menu STATUS parameter is set to
ALWAYS OFF, the on-screen display immediately deactivates. Press the
OSD button or use the front-panel display as a guide to reset the
ON-SCREEN DISPLAY menu STATUS parameter to ALWAYS ON or 2
SECONDS.
POSITION TOP, CENTER, BOTTOM
Controls the vertical alignment of the two-line status on the display
device screen. When TOP is selected, the two-line status appears
near the top of the display device screen. When CENTER is selected,
DISPLAYSSETUP ON-SCREEN DISPLAY
ALWAYS ON
2 SECONDS
ALWAYS OFF
TOP
CENTER
BOTTOM
SECAM
PAL
NTSC
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
DISPLAY SETUP
ON-SCREEN DISPLAY
FRONT PANEL DISPLAY
A/V SYNC DELAY
CUSTOM NAME
EDIT CUSTOM NAME
OFF
OFF
ON
OFF
ON-SCREEN DISPLAY
STATUS
POSITION
FORMAT
BACKGROUND
REMOTE STATE
2 SECONDS
TOP
NTSC
ON
ON
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
Parameter Default Setting Possible Settings
STATUS 2 SECONDS ALWAYS ON, 2 SECONDS,
ALWAYS OFF
POSITION TOP TOP, CENTER, BOTTOM
FORMAT NTSC SECAM, PAL, NTSC
BACKGROUND ON ON, OFF
REMOTE STATE ON ON, OFF
DISPLAYSSETUP ON-SCREEN DISPLAY STATUS
DISPLAYSSETUP ON-SCREEN DISPLAY POSITION
To Next Page
Loading...
