1 - 1
Technical Data
Type Isuzu A4BG1T, 4 cylinder in-line, turbocharged, direct injection
diesel.
Model
- JS130 A4BG1T-S1
- JS160 A4BG1T-S2
Bore 105 mm (4.13 in)
Stroke 125 mm (4.92 in)
Swept Volume 4329 cm
3
(264.2 in
3
)
Compression Ratio 17.0 : 1
Compression Pressure at 200 rev/min 31 bar (450 lbf/in
2
)
Firing Order 1, 3, 4, 2
Valve Clearance (cold)
- Inlet 0.4 mm (0.016 in)
- Exhaust 0.4 mm (0.016 in)
Dry Weight (approximately) 361 kg
Fuel System
Max. Speed (No Load)
- JS130 Less than 2570 rev/min
- JS160 Less than 2571 rev/min
Injection Timing (static) 12° BTDC
Injector Opening Pressure 180 bar (2630 lbf/in
2
)
Induction System
Air Cleaner Type 2 stage, dry element with in-cab warning indicator.
For further details, see engine service manual,
Publication No. 9806/2120
Note: New engines DO NOT require a running-in period. The engine/machine should be used in a normal work cycle
immediately; glazing of the cylinder bores resulting in excessive oil consumption, could occur if the engine is gently run-in.
Under no circumstances should the engine be allowed to idle for extended periods; (e.g. warming up without load).
Section K Engine
9803/6410
Section K
1 - 1
Issue 1
To Previous Page
Loading...
Need help?
General
