OPERATION
10 10
Digging Chain Setup
It is recommended that the digging chain is set up as
shown in illustration A. That is in a ‘V’ configuration with the
single tooth 1 in the centre and leading point of the ‘V’. The
‘V’ is formed by using progressively wider spacers 2 and
teeth 1, so that as the chain 3 rotates the cut becomes
wider. Refer to Trench Widths and Depths for width and
depth limits.
Trench Widths and Depths
Refer to Specifications on page 22.
Note: Optional Trencher Chain Kits and Trencher Cleaners
are available (see Specification at the end of this section).
A1461-1
To Next Page
Loading...
