Adjusting the Back Recline / Prone
The lever indicated by (A) and its
opposing lever on the other side of
the chair should be used collectively
to adjust the back recline positioning
of the Sunbeam.
Loosen the levers by turning them
anticlockwise. Once this has been
done the back should be free to
move into prone or recline.
Important Note:
It is important to remember that
the back is supporting your childs
weight and should therefore
be assisted at all times whilst
adjusting. The slot cut into the
plastic (B) is a visual indication
of the amount of adjustment
provided and this should never
be exceeded for safety reasons.
Once a suitable position of
prone/recline has been achieved,
lock the back into position by
tightening both levers (A) on either
side of the frame, turning them in
the clockwise direction until the
back is unable to be moved under
the weight of your child.
•
•
The weight of your child is supported by the levers (A). Ensure they are locked
securely into position at all times and thoroughly supported when adjusting.
!
The back recline should only be set to maximum when the chair is supervised
and your child is at rest. Activity in this position can potentially topple the chair.
!
A
B
To Next Page
Loading...
Need help?
General