13
Lateral Flexi & Lap Strap Adjustment
Positioning of Flexible
Lateral Support
The position of the flexible lateral
support can be adjusted to enable
the user to seat the child in a position
where the correct support is provided.
The allen key bolts (A) should be used
to set the vertical positioning of the
flexible lateral supports:
Slacken off the two bolts indicated
by turning them anticlockwise using
the allen key provided.
(Do not
completely remove these bolts!)
Once loose, the supports can be manually slid up and
down within its locating channel on the plastic back.
When the desired position has been acquired, use the allen key to re-lock
the support into place by tightening the bolts against the back of the chair.
Adjustment of Lap Strap
The Sunbeam comes with a lap strap
as standard which is easily adjusted
to suit the size of your child:
Un-clip the buckle (A) by raising
the plastic lever with your hands.
Once raised the white strap should
be free to slide within the buckle,
this allows you to either pull tight or
loosen off the strap depending on
the position desired for your child.
When you have achieved the strapping you require the buckle should simply be
snapped closed to trap the white strap and secure it in its place.
Adjustment of Flexible Lateral Support
Buckle (B) operates in the same manner as the lap strap buckle described above. In
this instance it is used to adjust the lateral strap which is fed around the flexible plastic
lateral support.
•
•
•
•
•
•
A
To Next Page
Loading...
Need help?
General