15
Operating the Rocking Mechanism
Use of the Rocking Action
(A) highlights the grab bar which is
used for rocking your child when the
chair is set in the rocking position.
Gently pushing on this rail will allow
the chair to rock gently and comfort
your child. It should be ensured that
the chair is located on a suitable flat
surface before rocking is performed.
The rail can also be used to carry the
chair when it is not in use.
Engaging / Disengaging
Rocking Motion
The rail shown in the photos opposite
allows the user to either engage or
disengage the rocking mechanism of
the chair. The rocking motion should
only be used if the child involved is
sufficiently comfortable under the
type of movement generated.
Engaging Rocking Motion
Tip the chair forward 5 degrees using
the rail indicated by (A).
Using the other hand the user should
then hinge rail (B) upward towards
them so that it protrudes at right
angles to the chair (B). The chair
should then be gently lowered back
down for rocking to be commenced.
Disengaging Rocking Motion
Hinge the rail down towards the
floor as far as it will go (C). Ensure
that it is securely in position.
•
•
•
Never rock the chair with the back reclined and the chair tilted. We recommend
supervision of the chair at all times when the rocking motion is being used.
!
A
B
C
To Next Page
Loading...