8- USER PROGRAMMING
8.4 STRENGTH
In the STRENGTH menu, you can change the drink strength for all available drinks at once in the range of
+10% to -10%.
1. Select the STRENGTH menu by using or and press to access it.
The following message appears on the display:
STRENGTH: + X %
2. Increase or decrease the drink strength using or .
3. Confirm the required value with . The new cup strength will be accepted immediately.
i
Note:
If you would like to modify the drink strength again, press .
8.5 DATE/TIME
You can set the date and time in the DATE/TIME menu.
The time setting needs to be adjusted at the start and end of daylight saving time.
You can change the drink strength for all available drinks at once in the range of +10% to -10%.
1. Select the DATE/TIME menu by using or and press to access it.
The date and time settings are shown on the display. The month setting is flashing.
2. Use and to select the correct value.
3. Press to go to the next field.
4. Repeat steps 1 and 2 for all fields:
MONTH → DAY → YEAR → HOURS → MINUTES
5. When all fields are set you will see the time.
i
Note:
If the dispenser has been shut down for longer periods, the date and time must be set again.
8.6 CLEANING DAYS
You can set the days that you want to clean or flush the dispenser in the CLEANING DAYS menu. Select the
CLEANING DAYS menu by using or and press to access it.
There are two submenus:
• CLEAN - set “CLEAN” days
• FLUSH - set “FLUSH” days
Caution:
It is mandatory to run the “Cleaning” program at least once a week to guarantee food safety.
8.61 Determining cleaning days
The dispenser only needs to run the “Cleaning” program once a week. You can select any day you prefer.
You must select at least one day with a maximum interval of 6 days in between. The table below indicates
which days can be combined (Yellow = Cleaning).
To Next Page
