8- USER PROGRAMMING
5. Use or to set the desired time (hours).
6. Confirm with . The option minutes setting flashes and is active.
7. Use or to set the desired time (minutes).
8. Confirm with . The new ECO time is shown on the display.
8.73 Setting the ECO boiler temperature
1. Use or to select the ECO TEMP submenu. The current ECO boiler temperature is shown on the display
(default = 63.0°C).
2. Press to enter the submenu. The temperature setting is flashing.
3. Use or to select the desired temperature.
4. Confirm with . The new ECO boiler temperature is shown on the display.
i
Note:
The lower the ECO boiler temperature is set, the longer it takes for the dispenser to become fully
functional again after exiting ECO mode.
8.8 TELEPHONE#
You can set the telephone numbers of operator and service in this menu. You can also select whether the
numbers should be displayed in case of:
• Cleaning is required (operator)
• A product pack is empty (operator)
• A malfunction is detected (service)
Select the TELEPHONE # menu by using or and press to access it. The status is shown in the display:
OPERATOR NR: 0123456789 by default.
There are four submenus:
• SHOW OPERATOR NR
• SHOW SERVICE NR
• SET OPERATOR NR
• SET SERVICE NR
8.81 ENABLED/DISABLED telephone numbers
1. Use or to select the SHOW OPERATOR NR or SHOW SERVICE NR submenu and press . The display
shows: Y (yes) or N (no)
2. Use or to select Y to activate the number display or N to deactivate the number display.
3. Confirm with . The new setting will then be shown continuously on the display.
8.82 Set telephone numbers
1. Use or to select the OPERATOR NR or SERVICE NR submenu and press . The display shows the
telephone number. The first digit is flashing: O: 0123456789
i
Note:
O = operator, S = service
To Next Page
