Rear Storage Compartment
The rear cargo area storage compartment
cover is held by a spring-loaded latch. In order
to remove the rear storage compartment cover,
use the following procedure:
NOTE:
The rear storage compartment latch should
not be used as cargo tie-down.
1. Flip up the pull loop so it is perpendicular
(straight up) to the top surface of the tray.
2. Pull up on the loop and twist it 90 degrees,
so it is parallel to the slotted hole in the tray.
3. Open the rear compartment cover.
DUAL TOP — TWO-DOOR
MODELS — IF EQUIPPED
If your vehicle is equipped with a Dual Top, you
must remove one of the tops from the ve-
hicle. If the soft top is removed, the pivot
brackets must also be removed from the
sport bar. The soft top was installed at the
factory for shipping purposes only. The soft top
and the hard top are to be used indepen-
dently. Removal is mandatory to prevent any
possible wear and tear on the soft top. Your
vehicle warranty will not cover damage resulting
from both tops remaining on the vehicle at the
same time for extended periods of time.
Removing The Soft Top — Two-Door
Models
1. Locate and remove the two boxes that con-
tain the following items:
• Right and left door frames
• Four door frame attachment knobs
• Right and left quarter windows
• Rear window
• Two rear window roll up straps
• Two Sunrider姞 secure straps (if equipped)
• Two rear swing gate brackets
2. Remove the hard top. Refer to “Freedom Top
Three-Piece Modular Hard Top — Front/Rear
Panel Removal” in this section.
3. Remove the soft top bow assembly pivot
bracket screws (two per side) using a #T30
Torx姞 head driver.
4. Disconnect the knuckles from the left and
right metal pivot brackets. Remove the soft top
from the vehicle and store in a clean, dry
location.
Rear Storage Cover
101
PAGE POSITION: 103 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
