EasyManua.ls Logo

Jeep 2013 Wrangler - Seat Belts in Passenger Seating Positions

Jeep 2013 Wrangler
380 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adjusting Upper Shoulder Belt
WARNING!
Position the shoulder belt height adjusters so
that the belt rests across the middle of your
shoulder. Failure to adjust the safety belt
properly could reduce the effectiveness of
the seat belt and increase the risk of injury in
a collision.
As a guide, if you are shorter than average, you
will prefer a lower position, and if you are taller
than average, you will prefer a higher position.
When you release the anchorage, try to move it
up or down to make sure that it is locked in
position.
NOTE:
The adjustable upper shoulder belt anchor-
age is equipped with an Easy Up feature.
This feature allows the shoulder belt an-
chorage to be adjusted in the upward posi-
tion without pressing the release button. To
verify the shoulder belt anchorage is
latched, pull downward on the shoulder belt
anchorage until it is locked into position
Seat Belts In Passenger Seating
Positions
The seat belts in the passenger seating posi-
tions are equipped with Automatic Locking Re-
tractors which are used to secure a child re-
straint system. For additional information, refer
to “Installing Child Restraints Using The Vehicle
Seat Belt” under the “Child Restraint” section.
The chart below defines the type of feature for
each seating position.
Driver Center Passen-
ger
First Row N/A N/A ALR
Second
Row
ALR ALR ALR
N/A Not Applicable
ALR Automatic Locking Retractor
If the passenger seating position is equipped
with an ALR and is being used for normal
usage:
Only pull the belt webbing out far enough to
comfortably wrap around the occupant’s mid-
section so as to not activate the ALR. If the ALR
is activated, you will hear a ratcheting sound as
the belt retracts. Allow the webbing to retract
completely in this case and then carefully pull
out only the amount of webbing necessary to
comfortably wrap around the occupant’s mid-
section. Slide the latch plate into the buckle until
you hear a "click."
31
PAGE POSITION: 33 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1

Table of Contents

Related product manuals