Jeep 2013 Wrangler - Door Frame Installation - Two-Door Models; Door Frame Installation - Four-Door Models

Door Frame Installation — Two-Door
Models
1. Unfold door frame and unscrew thumb-
screws.
2. Set the door frame pin into the hole on top of
the body side, behind the door opening.
3. After the door frame pin has been set into
the body side hole, carefully set the front of the
door frame into the rubber seal at the top of the
windshield.
4. Starting with the front of the door frame, clip
it over the metal side bar and then clip the rear,
making sure that the material for the side bar
covers is not pinched by the door frame.
5. Starting with the front knob, screw in and
tighten both knobs. Repeat on the other side.
Door Frame Installation —
Four-Door Models
1. Install the rear door frame first.
2. Set the door frame pin into the hole on top of
the body side, just behind the rear door open-
ing.
115
PAGE POSITION: 117 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1