1. Lift the seatback release lever and fold the
seatback forward.
2. Slowly flip the entire seat forward.
3. Return the seat to the normal position.
4. Raise the rear seatback using the assist
strap and firmly lock the seat into position.
Removing The Rear Seat —
Two-Door Models
WARNING!
• It is extremely dangerous to ride in a cargo
area, inside or outside of a vehicle. In a
collision, people riding in these areas are
more likely to be seriously injured or killed.
• Do not allow people to ride in any area of
your vehicle that is not equipped with seats
and seat belts.
• Be sure everyone in your vehicle is in a
seat and using a seat belt properly.
• In a collision, you or others in your vehicle
could be injured if seats are not properly
latched to their floor attachments. Always
be sure that the seats are fully latched.
1. Fold the rear seat forward following steps 1
and 2 under “Fold And Tumble Rear Seat” in this
section.
2. Press down on the release bar on each side,
and pull the seat out and away from the lower
bracket.
Rear Seat Release
Folding Rear Seat
86
PAGE POSITION: 88 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
