DUAL TOP — FOUR-DOOR
MODELS — IF EQUIPPED
If your vehicle is equipped with a Dual Top, you
must remove one of the tops from the ve-
hicle. If the soft top is removed, the pivot
brackets must also be removed from the
sport bar. The soft top was installed at the
factory for shipping purposes only. The soft top
and the hard top are to be used indepen-
dently. Removal is mandatory to prevent any
possible wear and tear on the soft top. Your
vehicle warranty will not cover damage resulting
from both tops remaining on the vehicle at the
same time for extended periods of time.
Removing The Soft Top —
Four-Door Models
1. Locate and remove the two boxes that con-
tain the following items:
• Right and left door frames
• Six door frame attachment knobs
• Right and left quarter windows
• Rear window
• Two rear window roll up straps
• Two Sunrider姞 secure straps (if equipped)
• Two rear swing gate brackets
2. Remove the hard top. Refer to “Freedom Top
Three-Piece Modular Hard Top — Front/Rear
Panel Removal” in this section.
3. Unbutton the side bow tether strap (both
sides).
4. Using the plastic reinforcement as a handle,
slide the tether strap up the side bow (both
sides).
5. The tether strap must be hooked onto the
pivot bracket prior to removal of soft top from
vehicle (both sides).
104
PAGE POSITION: 106 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
