4. Standing on the side of the vehicle, lift the
top by the side bow and the 2–bow (middle bow)
up and over the sports bar until the header rests
on the top of the windshield frame.
5. Make sure the Sunrider姞 bracket on the side
bows latches to the door rails (Sunrider姞 Mod-
els only).
6. Open the header latches and engage the
hook on each side onto the windshield loops (do
not close the latches).
7. If the swing gate brackets were removed,
install them by hooking the rear edge of the
bracket on the interior side of the body channel.
Then, rotate it rearward and over the channel
until it snaps onto the exterior part of the rail. To
be properly located, the bracket must only be
clipped to the shortened rail edge.
8. Move to the rear of the vehicle and gently
pull the sail panels over the rear roof bow.
128
PAGE POSITION: 130 JOB: @zeta.tweddle.com/InfoShareAuthoroChrysler/CLS_InfoShareAuthoroChrysler/GRP_Owners_Manual/JOB_1180441-en-2013-WRANGLER-EE-13JK72-126-ENG-AA/DIV_Owners_Manual_v1
To Next Page
Loading...
